User Manual

E-13
ENGLISH
Cooling Your Room
You must select the Cool mode if you wish to adjust the:
 Cooling temperature
 Fan speed when cooling
1
If necessary, press the (On/Off) button.
Result:  The operation indicator on the indoor unit lights up.
 The air conditioner starts up in the mode selected
when the unit was last used.
 The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism
to prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
2
If the is not displayed at the top of the remote control,
press the
button on the remote control one or more times until it appears.
Result:  The indoor unit beeps each time you press the button.
 The air conditioner runs in COOL mode.
Note You can change modes at any time.
3
To adjust the temperature, press the button one or more times until the
required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result:  Each time you press the button:
- The temperature is adjusted by 1°C
- The indoor unit beeps
 The air conditioner starts cooling, provided that the room
temperature is higher than the selected temperature.
 If the room temperature reaches the set temperature, the
air conditioner stops cooling, but the fan is still operating.
4
Select the fan speed by pressing the button one or more times until
the required setting is displayed:
Automatic (rotated :
)
Low
Medium
High
Result: Each time you press the button, the indoor unit beeps.
5
To control the direction of the air flow, refer to pages 18 and 19.
AVXWP@@_IB_E_24114.indd 13 2006-01-06 ¿ÀÈÄ 6:28:08