User Manual

E-14
Selecting the Heat Mode
You can select the Heat mode if you want to heat your room.
You can adjust the temperature and the fan speed when heating.
1
If necessary, press the (On/Off) button.
Result: 
 The operation indicator on the indoor unit lights up.
 The air conditioner starts up in the mode you selected last.
 The indoor unit beeps.
2
Press the button on the remote control until is displayed.
Result:
 The indoor unit beeps each time you press the button.
 The air conditioner runs in the Heat mode.
Note You can change modes at any time.
3
Press the button to adjust the temperature until the required tem
perature is displayed.
You can set the temperature between 16°C and 30°C.
Result:
 Each time you press the button:
- The temperature is adjusted by 1°C
- The indoor unit beeps
 If the room temperature reaches 5°C higher than the set
temperature, the air conditioner stops heating, but the fan
operates consistently.
 If the room temperature reaches 3°C lower than the set
temperature, the air conditioner starts heating again.
4
Press the button to select the fan speed until the required setting is
displayed.
Automatic (rotated :
)
Low
Medium
High
Result:
 Each time you press the button, the indoor unit beeps.
 The fan speed indicator increases and decreases
continuously and turns round each time you press
the
button.
 For the first 3~5 minutes, the fan may not operate to
prevent cool air from flowing out of the indoor unit.
It helps to warm the air in your room sufficiently.
Note The fan speed indicator of the indoor unit varies according to the
temperature in the Automatic fan speed.
5
To control the airflow direction, refer to pages 22 and 23.
Control Panel
AVXWH@@_IB_E_24831.indd 14 2006-01-06 ¿ÀÈÄ 6:05:52