User Manual

Checking the power consumption
Smart install
This function will display the amount of electricity consumed by operating the air
conditioner.
(You have to use the remote controller to check the power consumption but it will not be
displayed on the remote controller display.)
Press the 2
nd
F button and then press the Usage button on the remote controller while
the air conditioner is operating.
When the air conditioner is not in use, power consumption will not be displayed on the
indoor unit display even if you press the 2
nd
F  Usage button.

Indoor unit will display the amount of Power consumption for few seconds and then
return to usual status by displaying the indoor temperature.

Power consumption will be calculated from the moment the air conditioner is turned on
and calculated value will be reset when the air conditioner turns o.

0.1 is the default value of the electricity consumption and 99 is the maximum value. Unit
is in kWh.

Through Smart install function, installer can check if the installation was done properly.

If the installation was not done properly, error indicator will turn on the indoor unit display.
Therefore user will know if the installation was done properly or not.
If using a multi system, this function is not supported but the used hours is marked.
ARHSFSA
ARHSFNB
ARHSSDB
ARHSSDA
If using a multi system, this function is not supported.
English-11
PREPARATION01
A3050 EU_IB_DB68-04211A_HP_EN 228.indd 11 2014-2-28 9:25:10