Specifications

OfficeServ 7200 General Description Guide CHAPTER 2. OfficeServ 7200 Hardware
© Samsung Business Communications Page 2-7
Front View
Figure 2.3 Front View of the MCP
The components on the front panel of the MCP have the following functions:
Table 2.4 Ports and LEDs of the MCP
Ports & LEDs Function
LINK1~LINK3
Ports that connect the MCP with the LCP.
MISC1~MISC2 Ports that connect external music sources, paging device, loud bell, common
bell, or door bell.
SmartMedia
Port for installing NAND-type flash memory.
LAN
Port for establishing the 10Base-T/100Base-Tx Ethernet connection.
SIO
UART port (for tests).
RST
Button for resetting the MCP module.
RUN LED This LED indicates the status of the MCP.
- Off : Power is not connected.
- On : Booting.
- Blink : The program is operating correctly.
LAN LED This LED indicates the status of the connection to LAN.
- Off : MCP is not connected to LAN.
- On : MCP is connected LAN.
- Blink : MCP is transmitting or receiving data through LAN port.
SM LED This LED indicates the status of SmartMedia access.
- Off : The SmartMedia is not installed.
- On : The SmartMedia is installed but is not accessed.
- Blink : The SmartMedia is installed and is being accessed.
LCP LED This LED indicates the status of signalling message processing.
- Off : There is no message exchange between MCP and LCP.
- On : Messages are being sent/received to/from the LCP.
Smart Media
RST
SM LCP
RUN LAN
LINK 1
LINK 2
LINK 3 MISC1
MISC2
LAN
SIO
MCP