Specifications

3. Installation
3-1 Installing a Battery Pack
SAMSUNG Proprietary-Contents may change without notice
3-1
Figure 3-1 Charging the Phone and Battery
1. To attach the battery pack after charging, align it
with the phone about 1cm (1/2”) away from its
place so that the two arrows on the phone are
seen, the battery charge contacts pointing
downward.
2. Slide the battery pack upwards until it clicks
firmly into position. The phone is now ready to
be turned on.
3. To remove the battery pack, release it by
pressing the button on the rear of the phone.
4. Slide the battery pack downward about 1cm
(1/2”) and lift it away from the phone.
3-2 For Desk Top Use
1. Choose a proper location to install the charger
for desk top use.
2. Plug the power cord of the charger into an
appropriate wall socket. When the power is
connected correctly, the lamps turn on briefly.
3. To charge the battery pack, insert the battery
pack into the rear slot of the charger. The lamp
marked BATT on the front panel of the charger
lights up red.
4. If you do not wish to use the phone while
charging the battery, insert the phone with the
battery pack attached into the front slot of the
charger. The lamp marked PHONE on the front
panel of the charger lights up red.
Specifications using DTC (Desk Top Charger)
Battery Type Standard Battery Extended battery
(Li-ion, 1000mAh) (Li-ion, 1600mAh)
Charging Time 3 hours 4 hours
SEC Code GH43-10316B GH43-00121A
SCH-3500 MAIN
STANDARD
BATTERY
PACK (BTS350)
EXTENDED
BATTERY PACK
(BTE350)
DTC : DTC350
Press this button to
release the battery pack.