Service manual

Rev. 2.00

- 78 -

SRP-275

5. Disassembly and Assembly

To disassembly this printer, perform the assembly procedures described in the reverse sequence. First, the

main-assembly blocks are disassembled and divided into the sub assembly blocks, then each of the

individual blocks is disassembled.

When assembling the printer, check each part and its attachment position by referring to PPL(Product Parts

List).

5-1 SMP715 Printer mechanism unit Sub-assembly

5-1-1 Frame-main caulking assy

Part name Assembly procedure

① Frame-main

② Shaft-R/F idle

③ Shaft-gear pulley

④ Shaft-reduction A/C -2ea.

⑤ Shaft-ribbon frame L

⑥ Shaft-ribbon frame R

⑦ Shaft-ribbon feed

⑧ Shaft-lever_CC

1. Caulk ② Shaft-R/F idle, ③ Shaft-gear pulley, two ④ Shaft-

reduction A/C and ⑦ Shaft-ribbon feed on ① Frame-main.

2. Caulk ⑤ Shaft-ribbon frame L and ⑧ Shaft-lever_CC on ①

Frame-main.

3. Caulk ⑥ Shaft-ribbon frame R on ① Frame-main.

⑧ Shaft-lever_CC

① Frame-main

Shaft-R/F idle ②

③ Shaft-gear pulley

④ Shaft-reduction A/C -2EA

⑤ Shaft-ribbon frame L

⑥ Shaft-ribbon frame R

⑦ Shaft-ribbon feed

5-1-2 Ribbon-feeder assy

Part name Assembly procedure

① Ribbon-feeder

② Spring-ribbon-feeder

③ Gear-ribbon feeder

1. Grease ② Spring-ribbon-feeder with HG-31S and then insert ②

Spring-ribbon-feeder in ① Ribbon-feeder.

2. Insert ③ Gear-ribbon feeder to four hooks of ① Ribbon-feeder.