Service manual

Rev. 2.00
- 36 -
SRP-275
NOTES
If the print duty ratio is too high, the operation of the print head is stopped by the duty limit. In such
circumstances, the print speeds shown above cannot be guaranteed.
- cpi=characters per inch
(*1) Dot configuration
0.352mm
(0.014")
0.317mm (0.012")
0.3mm (0.012")
(wire diameter)
(*2) Character dimensions, characters per inch, characters per line
Character structure
Horizontal×Vertical
Character
structure
Character Set
Character
dimensions
W×H
Dot spacing
between
characters
Characters
per line
(cpi)
Characters
per inch
(cpi)
ANK
1.2×3.1mm
(.047×.122")
3 half dots 40 16
7 × 9
Graphics
1.7×3.1mm
(.070×.122")
0 40 16
ANK
1.6×3.1mm
(.063×.122")
3 half dots 33 13.3
9 × 9
Graphics
2.0×3.1mm
(.079×.122")
0 33 13.3
ANK
1.2×3.1mm
(.079×.122")
2 half dots 42 17.8
7 × 9
Graphics
1.6×3.1mm
(.063×.122")
0 42 17.8
ANK
1.6×3.1mm
(.063×.122")
2 half dots 35 14.5
9 × 9
Graphics
1.9×3.1mm
(.075×.122")
0 35 14.5
NOTES
The default font is 7×9; the dot spacing between characters is either 3 half dots or 2 half dots, depending
on programming.