Service manual

Rev. 2.00
- 127 -
SRP-275
7-2-4 Auto cut mechanism problems
Problem Probable Cause Level Checkpoint Action
Paper does
not cut despite
normal
operation of
Motor-DC
No intersection between Cutter
and Cutter lower
B Check for intersection
Reassemble
Auto cutter ass’y or
Cutter lower ass’y
Defective soldering between
Motor-DC and connector wire
B Check soldering condition Resolder as required
Motor-DC
does not rotate
Defective connection between
connector of Auto cutter ass’y
and PCB-AC ass’y
B
Check for connection of
connector
Make sure connection
of connector