Datasheet
Table Of Contents
- LCD Monitor
- Safety Instructions
- Introduction
- Connections
- Using the Software
- Adjusting the Monitor
- Troubleshooting
- Self-Test Feature Check
- Check List
- No images on the screen. I cannot turn on the monitor.
- I cannot see the On Screen Display.
- The screen shows strange colors or just black and white.
- The screen suddenly has become unbalanced.
- The screen is out of focus or OSD cannot be adjusted.
- LED is blinking but no images on the screen.
- There are only 16 colors shown on the screen. The screen colors have changed after changing the video card.
- There is a message that reads "Unrecognized monitor, Plug & Play (VESA DDC) monitor found".
- USB Monitor Check List
- There is no image on the screen. I cannot turn on the monitor.
- The screen of the USB monitor freezes.
- My USB monitor is connected but the screen is blank.
- My computer is on and the LED is blinking. However, only a blank screen is displayed on the monitor.
- Check the following items if there is trouble with the monitor.
- Q & A
- Specifications
- Information
- Appendix
Opens the on-screen menu and exits from the menu. Also use to exit the
OSD menu or return to the previous menu.
Customized Key
[
]
You can
customize key assignment for the Custom button according to
your preferences.
Note
You can configure the customized key for a required function via Setup >
Customized Key.
Brightness button [ ]
When OSD is not on the screen, push the button to adjust brightness.
>> Click here to see an animation clip
Adjust buttons [ ]
These buttons allow you to adjust items in the menu.
Enter button [ ] / SOURCE button
Activates a highlighted menu item.
Push the ' /SOURCE', then
selects the video signal while the OSD is off.
(When the
/SOURCE
button is pressed to change the input mode, a
message
appears in the upper left of the screen displaying the current
mode -- analog or digital input signal.)
Note
If you
select the digital mode, you must connect your monitor to the graphic
card's DVI port using the DVI cable.
>> Click here to see an animation clip
AUTO button
Use this button for auto adjustment.
>> Click here to see an animation clip
Power button [ ]
Use this button for turning the product on and off.
Power Indicator
This light is lit when operating normally, and blinks once when your ad-
justments are saved.
Note
See PowerSaver described
in the manual for further information regarding
power saving functions. For energy conservation, turn your monitor OFF
when it is not needed or when leaving it unattended for long periods.
Rear
Note
The configuration at the back of the product may vary from product to product.
Introduction