Owner`s manual

[]
Enter button [ ] /
Source button
Activates a highlighted menu item. /
Push the ' ', then selects the video signal while the OSD is off.
(When the source button is pressed to change the input mode, a
message appears in the upper left of the screen displaying the
current mode -- Analog or Digital input signal.)
Note : If you select the Digital mode, you must connect your
monitor to the graphic card's DVI port using the DVI cable.
AUTO button
When the 'AUTO' button is pressed, the Auto Adjustment screen
appears as shown in the animated screen on the center. Auto
adjustment allows the monitor to self-adjust to the incoming
Analog signal. The values of fine, coarse and position are
adjusted automatically. (Available in Analog mode only)
>>Click here to see an animation clip
Power button [ ] /
Power indicator
Use this button for turn the monitor on and off. /
This light glows Blue during normal operation, and blinks Blue
once as the monitor saves your adjustments.
Headphone
connection terminal [
]
See PowerSaver described in the manual for further information regarding power saving
functions. For energy conservation, turn your monitor OFF when it is not needed, or when
leaving it unattended for long periods.
Rear
(The configuration at the back of the monitor may vary from product to product.)
HAS Stand
1. POWER ON/OFF Switch
:
Use this button for turn the monitor on and off
2. POWER port
: Power cord, plugs into monitor and wall
receptacle.
Downloaded from ManualMonitor.com Manuals