User`s manual

4 HDVI Supported Output Resolutions
HDVI works with all DVI monitors that support any of the following resolutions:
Automatic Scaling: 1024x768, 1280x720, 1280x768, 1280x800, 1280x1024.
No Scaling: 1080p (1920x1080 @24/25/30), 1080i (1920x540 @48/50/60) and 720p (1280x720
@60).
To save the output resolution to the HDVI-10 flash EPROM, press ENT,1,2,3 on your Sony
infrared monitor. When you reboot the HDVI-10, it will restore the output mode from flash. The
default output mode is Auto Mode.
If the input signal is PAL, you can force the output to 50Hz using the RECALL button on your
Sony infrared remote control.
5 HDVI-10 With 2 Inputs
If you purchased the HDVI-10 with the dual input capability (Model# HDVI-10-2), you can switch
between inputs using the TV/VIDEO button on your standard Sony infrared remote control.
If the input format on both inputs is the same, the switch is immediate. If the input format on both
inputs is different, the switching will take few seconds.
6 Infrared Remote Functions
Starting with version 0.96, the infrared remote functions are disabled at boot time. You must press
ENT,4,5,6 to enable them. This is a list of all the functions that are available on the HDVI-10 using
a standard Sony Infrared Remote Control:
• Input Select “TV/VIDEO”: Switches between SDI input A and input B. This feature is
available only with the dual-input HDVI-10-2.
• Set Pass Through Mode “RECALL” or “JUMP”: Toggles the HDVI-10 to Pass Through
ON, Frame Rate Only and OFF. Default is OFF.
• Set Color Mode “0”: Toggles the color mode between RGB 0-255, RGB 16-235, Blue only
and Blue only Bright. The default is RGB 0-255.
• Set Output Mode “1”: Toggles the output mode between: Auto, 1024x768, 1280x720,
1280x768, 1280x800 and 1280x1024.
• Save Current Settings to Flash “ENT,1,2,3”: Saves the current settings to flash.
When you press ENT, the HDVI-10 will not accept any of the remote commands described
above until you press 3 more buttons. If the combination you press is different than 1,2,3,
the save to flash will be aborted.
When you are done using the remote, you can disable its functoionality by pressing “ENT,4,5,6”