Specifications

INFRARED REMOTE FUNCTIONS
4
Starting with version 0.96, the infrared remote functions are disabled at boot time. You
must press ENT,4,5,6 to enable them. This is a list of all the functions that are available
on the HDVI-10 using a standard Sony Infrared Remote Control:
· Input Select “TV/VIDEO”: Switches between SDI input A and input B. This feature is
available only with the dual-input HDVI-10-2.
· Set Pass Through Mode “RECALL” or “JUMP”: Toggles the HDVI-10 to Pass Through
ON, Frame Rate Only and OFF. Default is OFF.
· Set Color Mode “0”: Toggles the color mode between RGB 0-255, RGB 16-235, Blue
only and Blue only Bright. The default is RGB 0-255.
· Set Output Mode “1”: Toggles the output mode between: Auto, 1024x768, 1280x720,
1280x768, 1280x800 and 1280x1024.
· Save Current Settings to Flash “ENT,1,2,3”: Saves the current settings to ash.
When you press ENT, the HDVI-10 will not accept any of the remote commands
described above until you press 3 more buttons. If the combination you press is different
than 1,2,3, the save operation to ash memory will be aborted.
When you are done using the remote, you can disable its functionality by pressing
“ENT, 4,5,6"