Datasheet

http://www.samsungled.com
12 / 28
4.
Outline Drawing
&
Dimension
Recommended Land Pattern
*
This LED has built
-
in ESD protection device(s) connected in parallel to LED Chip(s).
*
The thermal pad is electrically isolated from the anode and cathode contact pads.
*
Measure the nearest point to the thermal pad as shown below. If necessary, remove
PSR of PCB to reach Ts point.
*
Thermal pad must be soldered to the PCB to dissipate heat properly. Otherwise, LED
can be damaged.
unit
:
mm
Tolerance
: ± 0.13
Ts Point
&
Measurement Method