Manual ( WRP100 )
1. Summary WRP100 (Model name) is a Wi-Fi repeater to transmit AV data. The Wi-Fi repeater receives from an AP and retransmits to display devices. The main goal of the Wi-Fi repeater is to enlarger communication coverage between AP and display device. To meet the goal, the Wi-Fi repeater is composed of two transceivers.
3. Wireless module Both wireless modules use HT40 (IEEE 802.11n) and each wireless module uses following channel (center frequency). * Lower band wireless module : #36(5190MHz), #44(5230MHz) * Upper band wireless module : #149(5755MHz), #157(5795MHz) Inverted F-type antennas are used for both wireless modules and four antennas are used for receive mode, two antennas are used for transmission mode. Following Modulation Modes are available.
Transmit signals are emitted through the Antenna B and the Antenna C for all MCS index (MCS Index 0~15 of above table) which means that the antenna A and the antenna D do not work during transmit state. Operating MCS Index 0~7, wireless module transmits same signal through the Antenna B and the Antenna C which means that one spatial same stream is transmitted through the Antenna B and the Antenna C.
other channels is not possible. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.
Command for FCC test * Channel selection command : wch channel_number, 1 (enter) - channel_number : 36, 33 for wireless lower band module - channel_number : 149, 157 for wireless upper band module Example) wch 36, 1 : #36 channel (5190MHz) selection wch 157, 1 : #157 channel (5795MHz) selection * Transmission data rate selection : tvec 0x41, mcs_index (enter) - mcs_index : 0~7 for number of spatial stream= 1 - mcs_index : 8~15 for number of spatial stream=2 Example) tvec 0x41, 2 : tvec 0x41, 11 : * Transc
