User's Manual

Table Of Contents

OfficeServ 500 Wireless LAN Service Manual/Ed.00 CHAPTER 4. MMC Programming

2.7 Setting the MMC831 MGI Parameters

This MMC provides a mean to configure the Internet Protocol(IP) addressing of the

MGI card(s). This MMC must be utilized MGI card(s) used on the system.

Table 4.4 MMC831 Parameters

Number Parameters Description

0 IP ADDRESS Specifies the IP address for the MGI card.

1 GATEWAY Specifies the designated IP gateway address used for contacting IP

devices beyond the local subnet.

2 SUB MASK Specifies the IP subnet mask. This parameter is used by the system to

calculate the range if IP devices(subnet) that are within ‘direct reach’

of the MGI(without having to go through the designated network IP

gateway).

3 PUBLIC IP The MGI will originate communications, to IP phones and VoIP

connections outside the local network, using this IP address. If this

IP address sets 0.0.0.0, 255.255.255.255 or default value then this

MGI card uses private IP only. See System IP Type on MMC 830.

4 STS PERIOD No entry required. Designates the timed message cycle to check the

remote IP status of MGI3 S/W.

5 VERSION No entry required. Used to indicate revision of MGI3 S/W.

6 MAC ADDR For your reference, and cannot be changed. The unique

hardware(MAC)

address of the MGI card.

7 CARD RESET Prompt to restart MGI card when IP address is changed. This use

for MGI 1 and 2 only, MGI3 is self restart automatically.

A MGI card

This MMC cannot be accessed unless there is a MGI card installed in the system.

Program Buttons

VOLUME Used to scroll through options

KEYPAD Used to enter selections

SOFT BUTTONS Move cursor left and right

SPEAKER Used to advance next MMC