User's Manual
Table Of Contents
- Purpose
- Document Content and Organization
- Conventions
- Reference
- Revision History
- Symbols
- Caution
- Overview
- 1 Overview of Wireless LAN
- 2 Overview of OfficeServ 500 Wireless LAN
- 3 Components of OfficeServ 500 Wireless LAN
- 4 Specification of OfficeServ 500 Wireless LAN
- Hardware of OfficeServ 500
- Installation
- MMC Programming
- Maintenance
- WLAN (802.11b/DSSS) Specifications
- Antenna Beam Pattern of WBS24
OfficeServ 500 Wireless LAN Service Manual/Ed.00 CHAPTER 4. MMC Programming
© SAMSUNG Electronics Co., Ltd. Page 4-3
1.4 Programming Procedure
This section describes the overall programming procedure. The procedure shall be
read carefully and thoroughly understood.
The programming procedure is described as follows.
Program Procedure Display Screen
1) Press the [TRSF] button, and enter 800.
2) Enter the PASSCODE
(Operator or Engineer password).
3) To enter the MMC, press the dial button [1] or
select the ‘ENABLE’ status by pressing the
[UP & DOWN] button.
4) Enter the program number.
Or, select the program number using the [UP & DOWN] button, and press [SPK].
Or, in an idle mode, press the [TRSF] button and enter the program number.
5) Proceed programming of the selected program.
PROGRAMMI NG MODE
ENTER PGM I D:
ENABL E TECH PROG
PASSCODE: * * * *
ENABL E TECH PROG
DI SABL E TENANT: 1