User's Manual
Table Of Contents
- Purpose
- Document Content and Organization
- Conventions
- Reference
- Revision History
- Symbols
- Caution
- Overview
- 1 Overview of Wireless LAN
- 2 Overview of OfficeServ 500 Wireless LAN
- 3 Components of OfficeServ 500 Wireless LAN
- 4 Specification of OfficeServ 500 Wireless LAN
- Hardware of OfficeServ 500
- Installation
- MMC Programming
- Maintenance
- WLAN (802.11b/DSSS) Specifications
- Antenna Beam Pattern of WBS24
CHAPTER 3. Installation OfficeServ 500 Wireless LAN Service Manual/Ed.00
Page 3-4
© SAMSUNG Electronics Co., Ltd.
3 Mounting the WBS24
The WBS24 is classified into wall WBS24 and desk WBS24 depending on
installation types. This section describes how to install a wall WBS24 or desk
WBS24.
3.1 Wall Type of WBS24
A WBS24 can be installed on the wall to offer the wireless LAN service as described
below :
Required Tools
Prepare the following tools in advance when mounting the WBS24 on a concrete wall.
Electric drill, hammer
Wall bracket
Cross-tip screwdriver(6.5 mm)
Two plastic anchors
Two cross-tip screws
WBS24
Mounting Instruction
1) Attach the <screw position diagram>, which comes with the WBS24, on the wall
where the WBS24 is to be mounted.
The screw position diagram
If the <screw position diagram> is not available, press an A4 paper sheet against the
bottom surface of the WBS24, and mark the two positions of the screw hole.