Regulatory and Safety Compliance Guide
W a r n in g ! I m p o rta n t S a f e ty I n s tr u ctio n s (Please read the approproate section that corresponds to the marking on your Samsung product before attempting to install the product.) C A UT ION R IS K OF E L E C T R IC S HOC K DO NOT OP E N CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). THERE ARE NO USER SERVICEABLE PARTS INSIDE. REFER ALL SERVUSING TO QUALIFIED PERSONNEL. This sysmbol indicated high voltage is present inside.
Regulatory Compliance Statements Your Samsung product is marked to indicate its compliance class: - Federal Communications Commission (FCC) - USA - Industry Canada Equipment Standard for Digital Equipment (ICES-003) - Canada - Voluntary Control Council for Interference (VCCI) - Japan - Bureau of Standards Metrology and Inspection (BSMI) - Taiwan - Ministry of Information and Communication (MIC) - Republic of Korea - Italian Post Ministry (Homologation) - Italy FCC Information FCC Class A Notice This device
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver.
ICES-003 Class A Notice - Avis NMB-003, Classe A This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. ICES-003 Class B Notice - Avis NMB-003, Classe B This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
European Class A Warning This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.(Class A product only) 정보통신기기 A급 기기(MIC Class A Notice) 이 기기는 업무용으로 전자파적합등록을 한 기기이오니 판매자 또는 사용자는 이 점을 주 의하시기 바라며 만약 잘못 판매 또는 구입하였을 때에는 가정용으로 교환하시기 바랍니다. 정보통신기기 B급 기기(MIC Class B Notice) 이 기기는 가정용으로 전자파적합등록을 한 기기로서 주거지역에서는 물론 모든 지역에서 사용할 수 있습니다. Italian Homologation Notice Questo apparecchio e fabbricato in conformita al D.
Important Safety Instructions(TV Only) 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings, Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, or other apparatus (including amplifiers) that produce heat.
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CA UT ION: TO R E DUCE T HE R ISK OF E L E C T R IC SHOCK , DO NOT R E MOV E COV E R (OR B A CK ). NO USE R SE RV ICE A B L E PA RT S INSIDE . R E FE R SE RV ICING TO QUA L IFIE D SE RV ICE PE R SONNE L . T his symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product. T his symbol alerts you that important literature concerning operation and maintenance has been included with this product.
Wiring the Mains Power Supply Plug(UK Only) IMPO RTAN T N O TICE T he mains lead on this equipment is supplied with a moulded plug incorporating a fuse. T he value of the fuse is indicated on the pin face of the plug and, if it requires replacing, a fuse approved to B S I1362 of the same rating must be used. Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover is required, it must be of the same colour as the pin face of the plug.
MPR II Compliance TCO'95-Ecological requirements for personal computers (TCO'95 applied model only) TCO'99-Ecological requirements for personal computers (TCO'99 applied model only) TCO'03-Ecological requirements for personal computers (TCO'03 applied model only) TCO'03 Recycling Information (TCO'03 applied model only) Medical Requirement (Medical applied model only) MPR II Compliance This monitor complies with SWEDAC(MPR II) recommendations for reduced electric and magnetic fields.
Labelled products must meet strict environmental demands, for example in respect of the reduction of electric and magnetic fields, along with physical and visual ergonomics and good usability. TCO Development Unit 1996-11-29 On the page this folder you will find a brief summary of the environmental requirements met by this product. The complere environmental criteria document may be ordered from: TCO Development Unit S-11494 Stockholm Sweden Fax: +46 8 782 92 07 E-mail (Internet): development@tco.
TCO'99-Ecological requirements for personal computers (TCO'99 applied model only) Congratulations! You have just purchased a TCO'99 approved and labelled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products.
The relevant TCO'99 demand requires that plastic components weighing more than 25 grams must not contain flame retardants with organically bound bromine or chlorine. Flame retardants are allowed in the printed circuit boards since no substitutes are available. Cadmium** Cadmium is present in rechargeable batteries and in the colour-generating layers of certain computer displays. Cadmium damages the nervous system and is toxic in high doses.
Emissions z z Electromagnetic fields Noise emissions Ecology The product must be prepared for recycling and the manufacturer must have a certified environmental management system such as EMAS or ISO 14 000 z Restrictions on o chlorinated and brominated flame retardants and polymers o heavy metals such as cadmium, mercury and lead. z The requirements included in this label have been developed by TCO Development in cooperation with scientists, experts, users as well as manufacturers all over the world.
user is encouraged to try to correct the interference by one or more of the following measures: z z z z Reorient or relocate the receiving device. Increase the separation between the equipment. Connect the equipment into an outlet on a circuit different from that to which the other device (s) are connected. Consult the manufacturer or field service technician for help.
