SM-408 ENGLISH ESPAÑOL ● DEUTSCH ● FRANÇAIS ● ● BG68-00350A http://www.samsungelectronics.
COMBO DRIVE SM-408 User's Guide FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Safety Precautions Contents The following diagrams illustrate the precautions to be taken when using your COMBO drive. You must not use the drive in any manner other than that specified in this guide. CAUTION Do not attempt to repair the COMBO drive yourself. Contact your dealer or local SAMSUNG representative for all repairs. If you make any adjustments or perform any operations other than those specified in this guide, you run the risk of exposure to hazardous radiation.
Your Combo Drive Upgrading the Firmware Flash Memory The product firmware can be upgraded by downloading the updated file from the following Web site: http://www.samsungelectronics.com System Requirements Before you install the COMBO drive, we strongly recommend that you check that your setup meets the system requirements listed below. 1. 2. 3. 4. 5.
Connecting the Cables 1. Power cable 2. Master/slave select terminal ● You already have an additional IDE device installed in your computer. First IDE cable Second IDE cable 3. IDE cable 4. Audio cable Mother board 1 Connecting the power cable The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the COMBO drive.
Installing the CD Record Utility To record data on a CD-R or CD-RW disc in the COMBO drive, you must first install the CD record utility. For compatibility reasons, you are recommended to uninstall any existing software of the same type before installing this utility. 1 Insert the disc supplied with the COMBO drive in the drive. 2 Follow the instructions displayed on the screen to install the utility. Refer to the separate utility documentation for further details.
Using the COMBO Drive To play audio or video CDs and/or DVDs in your COMBO drive, proceed as follows. 1 Push the power button and boot the computer. 5 Do not touch the surface of a disc; hold it by the edges. 2 After booting the computer, open the disc compartment by pressing the Eject button. 3 Insert the disc (CD/DVD) and close the disc 6 To clean a disc, polish lightly from the inside of the disc to the outside with a soft cotton cloth. compartment by pressing the Eject button.
Recommended Disc Types ◆ Network Drive CD-R SKC, Sony, Taiyo Yuden, TDK, Yamaha 1 Copy the network drive contents to the hard disc and then from the hard disk to the COMBO drive. ◆ CD-RW Mitsubishi, Ricoh, SKC CD-ROM Drive 1 Clean the source CD, if necessary. DVD Region Protection Coding (RPC): 2 Create an image file and then copy the image file to the COMBO drive. 3 Check the CD-ROM drive record speed.
Solving Technical Problems Problem The COMBO drive is not detected by the computer. After installing the COMBO drive, the PC gets slower. Meaning / Solution ◆ Check that the power, audio and IDE cables are correctly connected to the computer. ◆ Change the IDE cable and reconnect it to the computer. Preferably, connect a second IDE cable to the COMBO drive in master mode; see page 7 for further details. ◆ Check the position of the jumper in the master/slave select terminal.
Printed in Korea
