User's Manual

30 Users Manual
You do not have to turn the computer over or tip it on its side to change
devices. Simply tilt the computer up at the front about 10 cm and locate the
Flex-Bay latch. See Figure below for the location of the Flex-Bay latch. The
computer in the figure is tilted on its side for clarity.
2. Click Remove / Swap. A Device Change popup window stating, “Please wait until
the system processes the device change” appears then another popup window
appears and says, “Please remove or swap your bay device(s) now and press OK.”
3. Tilt the computer up & locate the smart bay latch.
4. Slide and hold the device latch toward the front of the computer.
5. Slide the device out.
6. ClickOK. The message “Please waituntilthesystem processes the device change”
appears again.
7. Click OK to close the Softex Bay Manager Utility.
To insert a device:
1. Open the Softex Bay Manager Utility.
You do not have to turn the computer over to change devices. Simply tilt the
computer up and locate the Flex-Bay latch. See “Bottom” on page 7 for the
location of the Flex-Bay latch.
2. Click Device Insert. A popup window appears stating “Please insert your device(s)
into the bay now and click OK.”
Flex-Bay Latch