User Guide

E
Complete a Walk Test Troubleshooting
Once you’ve nished setting up your ADT Security Hub and
detectors, you should perform a Walk Test to ensure that all
your devices are installed and working correctly.
If the ADT Door and Window Detector did not pair successfully with
the ADT Security Hub, follow these instructions to reset it:
If you’re still having trouble connecting the ADT Door and
Window Detector, please visit SmartThings.com/Support-ADT
for assistance.
1.
2.
3.
4.
Select System Settings from the Home screen on your
ADT Security Hub.
Press and release the button on the top of the detector
twice.
Press and hold the button. The red LED will begin to blink
quickly, and after a short period of time it will stay on.
Release the button and after 5 seconds the red LED will
begin to blink slowly.
Use the SmartThings app to complete setup..
Enter the Master User Code.
Select Walk Test.
Select Sensors Test and follow the on-screen instructions.
Select Console Test and follow the on-screen instructions.
Tap or the Home button to exit Test Mode.
Note: It is strongly recommended that you repeat this Walk Test
on a monthly basis.
• If a detector fails the Sensors Test, check that it’s
been installed correctly or visit SmartThings.com/
Support-ADT for assistance.