Quick Start Guide

ManualsBrandsSamsung Electronics ManualsElectronicsIndoor Access Point

AC Plug

Power Adapter

Power

Connector

Network

Connector

SmartThings

Product Information Guide

SmartThings

Hub

DOC-HV2-R001

Power Reset USB

Network

(ethernet)

Status LED

Product Information Guide

This guide contains information regarding setup, safety, handling, disposal and

recycling, regulatory, and warranty for the SmartThings Hub.

SmartThings Hub Setup

The SmartThings Hub works best if installed in a central location to where your

SmartThings will be connected. The recommended separation distance from the

user for this equipment is 7.6 inches (20 cm).

• Connect your SmartThings Hub to your Internet router using the included

Ethernet cable.

• Connect your SmartThings Hub to power using the provided power supply.

• Continue setting up your Hub by going to www.smartthings.com/start on you

smart phone and following the on screen instructions.

Disconnect the network cable and power adapter or any other connected

peripherals if any of the following conditions exist:

• The power cord or connector is damaged or frayed.

• You want to clean the Hub (see Important Safety Instructions).

• The Hub or attached cables are exposed to rain, water/fluids,

or excessive moisture.

• The Hub Power Adapter is damaged or had be dropped and you suspect it

needs to be serviced.

Battery Backup Installation

Disconnect the network cable and power adapter or any other connected

peripherals before installing batteries (4xAA):

• Slide bottom cover off.

• Insert 4 AA batteries.

• Slide bottom cover on till it snaps in to place.

NOTE: Hub does not recharge batteries.

Front

Back

Avoid installing the SmartThings Hub near or inside sources

of metal, radio or electromagnetic interference.

Vermeiden Sie die Installation des SmartThings Hubs in oder

in der Nähe von Metall, Funkantennen oder anderen elektro-

magnetischen Störsendern

Éviter l’installation du Hub SmartThings a à proximité ou a à

l’intérieur d’objets métalliques ou de sources d’interférences

radioélectriques ou électromagnétiques.

WARNING: No user-serviceable parts inside. Refer all servic-

ing to qualified service personnel.

Warnung: Keine Wartung einzelner Teile durch den Nutzer.

Wenden Sie sich nur an qualifiziertes Servicepersonal für

Wartungen

Attention: l’équipement SmartThings ne doit être en aucun

cas ouvert par l’utilisateur luimême. Pour l’entretien et/ou la

maintenance, contacter le personnel qualifié.

3 4

Summary of content (2 pages)

PAGE 1
SmartThings Hub Product Information Guide Battery Backup Installation This guide contains information regarding setup, safety, handling, disposal and recycling, regulatory, and warranty for the SmartThings Hub. Disconnect the network cable and power adapter or any other connected peripherals before installing batteries (4xAA): SmartThings Hub Setup The SmartThings Hub works best if installed in a central location to where your SmartThings will be connected.
PAGE 2
Important Safety Instructions • Read, keep and follow these instructions. • Heed all warnings. • Do not use this product near water or expose the product to dripping or splashing of any water or liquid. • Clean only with a dry cloth. • Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. • Only use attachments and accessories specified by the manufacturer. • Read our Product Usage Guidelines at: http://SmartThings.