User's Manual

ManualsBrandsSamsung Electronics ManualsElectronicsWLAN Transmitter Module

Table Of Contents

Subject to change without notices

User manual

Product description: IEEE 802.11g/n 2x2 USB module

WNC model name: DNUB-S1

Samsung model name: DNUBS1

Version:

V2.0

Networking Product Center

Wistron Neweb

Corporation

No. 10-1, Lin-hsin I Road, Science-Based Industry Park, Hsinchu 300, Taiwan, R.O.C.

Tel: +886-3-666-7799

Fax:+886-3-666-7711

Subject to change without notices

DNUB-S1 delivery specification

Summary of content (13 pages)

PAGE 1
User manual Product description: IEEE 802.11g/n 2x2 USB module WNC model name: DNUB-S1 Samsung model name: DNUBS1 Version: V2.0 Networking Product Center Wistron Neweb® Corporation No. 10-1, Lin-hsin I Road, Science-Based Industry Park, Hsinchu 300, Taiwan, R.O.C.
PAGE 2
1. Introduction DNUB-S1 is a USB embedded module compliant with IEEE802.11n Draft 2.0 standard. The core chipset is from Broadcom, part number BCM43231. 2.
PAGE 3
. Hardware Architecture: 3.1 Main Chipset Information Item MAC/BBP/Radio Transceiver/PA Vender Broadcom Part number BCM43231 3.2 Circuit Block Diagram The major internal components and external interfaces of DNUB-S1 are illustrated in Figure 1-1. JTAG ARM Internal Bus USB 2.0 ROM RAM Draft 802.11n MAC Draft802.11n PHY 2x2 Radio Securuty GPIO SPROM I/F BCM43231 Figure 1-1 DNUB-S1 Major Component and System Interface 3.
PAGE 4
Bottom view 3.4 Antennas Information Two trace antennas supporting both TX & RX. ANT 1 ANT 0 3.4..
PAGE 5
3.4.
PAGE 6
3.4.3 Efficiency The efficiency is 35%. 3.4.4 Gain Table Peak gain (dBi) MHz XY plan XZ plan YZ plan 2400 -3.03 -0.09 -1.32 2450 -2.15 0.23 -0.58 2500 -1.89 0.6 0.33 4.
PAGE 7
USB FPC Cable & connector DNUB-S1
PAGE 8
5. Mechanical drawing 5.
PAGE 9
6. Specifications: 6.1 Supply Voltage: 5V±5% DC 6.2 Current Consumttion 5V supply only Condition Unit Peak 11b TX mode@16dBm 265 11g TX mode@15dBm 260 11b Throughput . Tx 400 11g Throughput . Tx 390 Associated and idle with power saving 170 HT20 Tx MCS8 420 HT20 Tx MCS15 390 HT40 Tx MCS8 580 HT40 Tx MCS15 550 mA (Typical level, with +/- 50mA tolerance) 6.3 RF power (Typical power level per chain with +/- 2.
PAGE 10
Notes: Power level for different country domains is country dependent and Broadcom driver & SPROM will control the regulatory power table. Therefore, the actual power may be lower than this number. 6.4 RF Sensitivity (Typical sensitivity level, 2RX with +3/- 6 dB tolerance) ( unit:dBm ) 20MHz BW 2412 MHz 2442 2472 40MHz BW 2412 MHz 2442 2472 1Mbps 2Mbps 5.
PAGE 11
7. NOTICE FCC ID: A3LDNUBS1 NOTICE In accordance with FCC Part 15, the A3LDNUBS1 is listed as a Modular Transmitter device. End products that include the A3LDNUBS1 shall have the words “Contains Transmitter module FCC ID: A3LDNUBS1” on an exterior label l. This device complies with Part 15 of FCC Rules.
PAGE 12
Information for Canadian Users (IC Notice) IC : 649E-DNUBS1 The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-003.
PAGE 13
8.1 Installation Procedure 1. Be sure to use the proper antistatic handling techniques 2. Insert the DNUBS1 into the machine and fix it by bracket.