User's Manual

ManualsBrandsSamsung Electronics ManualsElectronicsBluetooth Module

Table Of Contents

빈 페이지

Version 1.0 Samsung Electronics page 1 of 3

User Manual for BTM740B (for AIP PC)

1. Introduction

BTM740B BT Module containing Bluetooth 3.0 / Mac compatible Bluetooth Module/ Baseband

optimized Radio with UART interface.

2. Hardware Configuration

2.1 Main Chipset Information

Item IC Vendor Part Number

Bluetooth 3.0

MAC/Baseband/Radio

CSR CSR8670

2.2 Block Diagram

Block Diagram of BT Module is as Figure.1.

Figure.1 BTM740B Block Diagram

Summary of content (6 pages)

PAGE 1
User Manual for BTM740B (for AIP PC) 1. Introduction BTM740B BT Module containing Bluetooth 3.0 / Mac compatible Bluetooth Module/ Baseband optimized Radio with UART interface. 2. Hardware Configuration 2.1 Main Chipset Information Item Bluetooth 3.0 MAC/Baseband/Radio IC Vendor Part Number CSR CSR8670 2.2 Block Diagram Block Diagram of BT Module is as Figure.1. Figure.1 BTM740B Block Diagram Version 1.
PAGE 2
3. Pin Description Pin descriptions are as Table.3. Table.3 Pin Description Version 1.
PAGE 3
4. Detail Specifications - Frequency : 2402~2480 MHz - Number of Channel : 79ch - Oscillation : VCO - Operating Voltage : TYP. DC 3.3 V - Current Consumption : Max.100mA - Dimension : 22 mm X 26 mm X 2.5 mm - Weight : 2.5g - Operating Temperature : -10℃ ~ +50℃ - Communication : Semi-Duplex Operation - Modulation : 2FSK, pi/4 DQPSK, 8DPSK *This wireless device may cause propagation interferences so can’t available for life-saving services. Version 1.
PAGE 4
6. Notice l. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 5
device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains FCC ID: A3LBTM740B ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules.
PAGE 6
IC Statement RSS-Gen 7.1.2 Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.