Modular installation manual WARNING i. We recommend to keep 20cm distance when installing this module. ii. This module should not be installed and operating simultaneously with other radio without additional evaluation or FCC filing. iii.
User Manual for BTM730B (for AIO PC) 1. Introduction BTM730B BT Module containing Bluetooth 3.0 / Mac compatible Bluetooth Module/ Baseband optimized Radio with UART interface. 2. Hardware Configuration 2.1 Main Chipset Information Item Bluetooth 3.0 MAC/Baseband/Radio IC Vendor Part Number CSR BC05MM 2.2 Block Diagram Block Diagram of BT Module is as Figure.1. Figure.1 BTM730B Block Diagram Version 1.
. Operational Description BTM730B BT Module is RF communication controller which is equipped with AIO PC for the users who use wireless devices. A number of channels are 79 which are based on IEEE 802.15.1/1a and frequency range is 2402MHz ~ 2480MHz. Each channel has a bandwidth of 1 MHz. - Transmitter Baseband processor uses FFHS (Frequency Hopping Spread Spectrum) scheme to avoid interference from other signals by hopping to a new frequency after transmitting or receiving a packet.
- RF Specifications RF specifications are as Table.2. Parameter Min Typ. Max Unit 2.402 - 2.480 GHz Output power 0 6.5 20 dBm TX Spurious Emission 30.0MHz to 1.0GHz 1.0GHz to 12.5GHz 1.8GHz to 1.9GHz 5.15GHz to 5.3GHz - - -30 dBm TX Frequency Tolerance -75 - 75 KHz Carrier Frequency Drift -20 - 20 KHz - - 1 MHz Delta F1 140 - 175 KHz Delta F2 115 - - KHz Delta F2 / F1 0.8 - 3 - - - 0.1 % Maximum Input Level BER at -20dBm - - 0.
4. Pin Description Pin descriptions are as Table.3. Table.3 Pin Description Version 1.
5. Detail Specifications - Frequency : 2402~2480 MHz - Number of Channel : 79ch - Oscillation : VCO - Operating Voltage : TYP. DC 3.3 V (Operating Range : 3.1V~3.6V) - Current Consumption : Max.100mA - Dimension : 22 mm X 26 mm X 2.5 mm - Weight : 2.5g - Operating Temperature : -10℃ ~ +50℃ - Communication : Semi-Duplex Operation - Modulation : 2FSK, pi/4 DQPSK, 8DPSK - Label Location of Module: - Host system labeling instruction : We add following statement at label of each host.
* Please use only allowed PIFA antenna below. * Use other antenna may subject to additional testing and filing to FCC. Version 1.
