Specifications

6
TD30 Cassette Tape Deck
Instructions for Installing the Cassette Tape Deck
1 Disconnect the power cord from the AC source and the Expedition cabinet.
2 With the rear of the Expedition cabinet facing you, lie the cabinet face down on a soft surface so as not
to scratch the front grille. (figure 1)
3 Using a Phillips screwdriver, remove the Cassette Connection Access Plate screws, Access Plate and
lower rear panel screws as in figure 1. Set aside screws for re-assembly and save the plate if the cas-
sette has to be removed. The plate is not needed when the cassette is installed.
4 Lift the mixer panel from the bottom and disconnect the Switch Cable from connector marked CN206A,
located on the lower circuit board, as in figure 2. This will allow you to lift the mixer higher giving you
better access to the circuit boards.
CH1
CH2
CH3/4
Cassette Connection
Access Plate
Cassette Connection
Access Plate Screw
Cassette Connection
Access Plate Screw
Lower Rear
Panel Screw
Lower Rear
Panel Screw
figure 1
figure 4
figure 3
figure 2
Switch Cable
Connector
CN206A
WARNING! Installation of the cassette deck should be done by qualified personnel.
Samson assumes no responsibility, personal liability or liability for Expedition cabinets.
Cassette Cable
Channel
Lower
Circuit Board
Upper
Circuit Board
2-pin Connector
CN513
6-pin Connector
CN501
2-pin Connector
CN207A
CH1
CH2
CH3/4
PLAYER
RECORDRER
SOFT
EJECT
RECORD
LEVEL
REC/PLAY DECK
AUTO LEVEL CONTROL
AUTO STOP
ONE TOUCH
REC
STEREO PITCH CONTROL CASSETTE RECORDER/PLAYER
PLAY REW FFWD ST/EJ PAUSE
PLAY
LEVEL
PITCH
CONTROL
-10 - 3 0 +4+12
Cassette
Connection
Access Plate
Screw
Cassette
Connection
Access Plate
Screw
Lower Rear
Panel Screw
Upper Cassette
Screws
Lower Rear
Panel Screw