Specifications

MP1020 Mounting Plate

3. Using the four M6 phillips head machine screws and four M6 spring washers supplied with the

MP1020, securely fasten the MP1020 Mounting Plate to the top of the Expedition as in figures 3 and 4.

4. Follow the OmniMount

instructions to complete installation.

OmniMount

clamp plate

Samson MP1020

mounting plate

M8 nut

M8 spring

washer

M8 x 20 phillips

machine screw

Fly Point Cover

Fly Point

figure 1 figure 2

WARNING! Samson assumes no responsibility or liability for either the structure or OmniMount

hardware for the

mounting of Expedition cabinets. Installation should be done by qualified personnel.

The Samson Expedition MP1020 Mounting Plate is designed to be used in configuration with

OmniMount® models 100-STMP and 100-WB. In fixed installations where you wish to mount the

Expedition to a ceiling, use the OmniMount

model 100-STMP mount. In fixed installations where you

wish to mount the Expedition to a wall, use the OmniMount

model 100-WB mount. Once you’ve decided

where your Expedition cabinet(s) will be mounted, read the instructions that accompany the

OmniMount

and then follow the steps below.

Parts list:

1 MP1020 mounting plate 4 M8 x 20 phillips head machine screws

4 M6 x 25 phillips head machine screws 4 M8 spring washers

4 M6 spring washers 4 M8 nuts

Instructions for Assembly

1. Remove the fly point covers, by lifting the tab at the rear of the covers, from the top of the Expedition

cabinet revealing the fly points. (figure 1)

2. Securely fasten the OmniMount

Clamp Plate to the Samson MP1020 Mounting Plate with the four

M8x20 phillips head machine screws, four M8 spring washers and four M8 nuts supplied with the

MP1020 as in figure 2.