Operation Manual

ENGLISHFRANÇAISDEUTSCHEESPAÑOLITALIANO

UB7 Callouts

1. Input Connector - Connect the input device via the

mini-XLR connector.

2. Power/Mute Switch - Press and hold to turn the unit

on or off. Press and release to mute or unmute the

transmitter.

3. Antenna - Permanently attached transmitter antenna.

4. Belt Clip - Use this clip to fasten transmitter to a

belt or guitar strap.

5. UNLOCK/LOCK Switch - Locking the system controls

prevents accidental muting or channel adjustment

during performance.

6. Input GAIN Control - This control adjusts the

transmitter input sensitivity to work with microphone

and instruments input signals. For optimal

performance set the input GAIN control to where

you see the UR7 PEAK indicator start to light under

high levels, then turn down slowly until the PEAK

light stops lighting or only occasionally ﬂashes

during the loudest input each channel will see

7. Battery Holder - Insert two standard AA (LR6)

batteries here, being sure to observe the plus

and minus polarity markings shown. Although

rechargeable Ni-Cad batteries can be used, they

do not supply adequate current for more than four

hours.

WARNING: Do not insert the batteries backwards; doing

so can cause severe damage to the UR7 and will void

your warranty.

8. Status Indicator - This LED lights green when the

transmitter is powered, and lights red when the

transmitter is muted.

9. LCD Display - Displays the group, channel and

battery level information.

10. IR Lens - This window is used to capture the infrared

signal sent from the UR7 during the IR SET to

channelize the transmitter.

1 2