Owner's Manual
Quick
Start
Position the VH12
transmitter
about
6-12"
{15-30
cm)
from the front of the
SR212
receiver
with
the
transmitter's
IR
window facing the IR
transmitter
on
the front panel
of
the
SR212
receiver.
Press and hold the
SR212
CH
A SELECT button
to
set the transmitter to the same channel as
the
receiver via infrared transmission
When
the
transmission is complete,
the
SR212
will receive
RF
signal and the tone key from
the transmitter. The
CH
A READY indicator will li
ght
on the
front
panel
of
the
SR212
receiver.
Repeat these steps for the
CH
B
transmitter
and receiver.
CH
A and
CH
B available frequency
channels do not overlap, so you can set
the
two receivers
to
the same channel number or letter.
Turn on your connected
amplifier
or mixer,
but
keep
the
volume all the way down. Set the
Volume knob
on
the
SR212
fully
clockwise (to its
"10"
setting). This is unity gain.
Speak or sing into the microphone. Slowly raise the volume
of
your
amplifier
or mixer
until
the
desired leve l is reached.
If you
find
the
system has noticeable dropouts, reduced overall working range, or unexpected
noise bursts, change the operating channel of the system using the steps above.
When
using
multiple
systems
in
the
same
frequency
band,
each
system
must
be
set
to
a
different
operating
channel.
12
SAMSON