Owner's Manual
Table Of Contents
- Quick Start Guide
- Important Safety Information
- Introduction
- Charging the Go Mic Mobile Receiver Battery
- Go Mic Mobile Receiver (GMM) Callouts
- HXD2 Handheld Transmitter Callouts
- PXD2 Belt Pack Transmitter Callouts
- Getting Started - Pairing
- Getting Started - Audio Connections
- Getting Started - Setting the system volume
- MIX / 2 CH Switch
- Mounting Instructions
- Affixing to a cold shoe adapter
- Specifications
- Declaration
- Product Registration
Go Mic Mobile
10
1. Input Connector - Connect the input device
via the mini-XLR connector. The PXD2 is
supplied with a lavalier microphone.
2. Status Indicator - This LED displays the
operation mode
3. Power/Pair Switch - Press <5 seconds to turn
the unit on or off. Press >5 seconds to enter
pairing mode.
4. Input GAIN Control - This control adjusts the
transmitter input sensitivity.
5. Battery Holder - Insert two standard AA (LR6)
batteries here, being sure to observe the plus
and minus polarity markings shown.
WARNING: Do not insert the batteries
backwards; doing so can cause severe
damage to the PXD2 and will void your
warranty.
6. Plastic Screwdriver - Used to adjust the input
GAIN control.
PXD2 Belt Pack Transmitter Callouts
12 3
4
5
6