Owner's Manual
Table Of Contents
- Owner's Manual
- Important Safety Information
- Introduction
- Quick Start
- Multiple System Setup
- Charging the AH8 Transmitter
- Wearing the AH8 Transmitter
- AH8 Headset Transmitter Callouts
- CR88x Receiver Features - Front Panel
- CR88x Receiver Features - Rear Panel
- Rack Mounting
- Troubleshooting
- Specifications
- Operating Bands and Frequency Ranges
- Headset Wireless System
- Product Registration
14
CR88x Receiver Features - Rear Panel
1. DC Input - Connect the supplied power adapter here, using the strain relief as shown in the
illustration below. WARNING: Do not substitute any other kind of power adapter. Doing so
can cause severe damage to the CR88x and will void your warranty.
2. BALANCED OUTPUT - Use this electronically balanced low impedance (600 Ohm) XLR jack
when connecting the CR88x to professional (+4dBu) audio equipment. Pin wiring is as
follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
3. UNBALANCED OUTPUT - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the CR88x to consumer (-10dBV) audio equipment. Wiring is as follows: tip hot,
sleeve ground.
Using the strain relief: Gather up a loop of
wire and pass it through the strain relief,
then pass the adapter plug through the
loop in order to create a knot.