Assembly Instructions

9. If you nd the panel pulling from the wall, bracing may be necessary. Use 1 x 4 boards, or other
dimensional lumber, and brace the panels where needed as illustrated. (Figure 3)
10. Allow the silicone to cure. Make all remaining cut outs. Silicone between the panel and the
substrate along the cut out edge and install the accessory.
11. Once the silicone is set up and the panel is secure, pull away the protective plastic an install the
trim and cove.
12. Install any surface mounted items, such as grab bars, shower seats, etc., make sure that the screw
hole drilled into the Transolid panel is 1/16” larger than the screw so that the accessory is held in
place by the wood blocking and not the Transolid panel. If the accessory is to be ADA compliant,
please refer to the ADA manual for the proper heights and locations.
Transolid, Div. • 400 Dietz Road • Warren, OH 44483 • [phone] • www.transolid.com