User Manual

12
7. To set the playback volume in the
headphones, adjust the Output
volume slider at the bottom of the
Sound dialog box (figure 15).
At this point you can begin using your
microphone with most any audio
recording software, but you need to select
it as an input and output device within
the DAW. When selecting the inputs and
outputs just look for and select the Go Mic.
When recording in your DAW with
monitoring turned on, you may
experience a delay on the signal
playback, commonly know as latency.
The amount of latency depends on
the speed of your computer, available
memory and the number of tracks you
are recording. You can set the Go Mic
to Direct Monitor mode to listen to
the signal directly off the input of the
microphone to eliminate the latency.
Using the Direct Monitor
1. To turn direct monitoring on or off,
open the Audio/MIDI Setup (figure
16) utility located in the Utility folder
inside the Applications folder.
2. Now click the checkbox in the
Thru
column in Audio/MIDI Setup.
Go Mic
Figure 15
Figure 16
Installing the Go Mic