Operation Manual

Setup
The MD2 Pro can be quite useful on stage or in the studio for connecting
unbalanced audio sources or instruments with pickups. By utilizing the MD2
Pro, the signal can be sent cleanly for long distances while benefiting from
the low noise and common mode rejection provided by the balanced low-level
output. The diagram following shows a typical hook-up for a stereo keyboard
connected to a keyboard amplifier and a PA system.
• Set the volume controls of your audio system to the off position.
• Connect your instrument or other audio source to the MD2 Pro INPUT
jacks.
• Connect the THRU outputs to a monitor speaker or sub-mixer.
• Connect the BALANCED OUTPUT jacks to the microphone inputs of a
mixer or other audio device.
• Raise the level of the audio system to the appropriate level.
• If you hear a hum or buzz set the GROUND LIFT switch to the LIFT
position.
• If you hear distortion, set the pad switch to either the -15dB or -30dB
position. You may need to adjust the input level of the mixer to make up
for the attenuated signal.