Specifications

7
Guided Tour - Model 2000 Rear Panel
1. Fuse sled - This contains a fuse holder and shows the currently selected volt-
age rating for your Model 2000. Make sure the voltage rating is correctly set
before powering up the amplifier! Fuse ratings are 5 amp for 115 VAC and
2.5 amp for 230 VAC. For information on how to change the voltage rating, see
Appendix C on page 18.
2. AC input - Connect the supplied standard 3-pin “EEC” plug here.
3. Fan - The fan provides vital cooling to your Model 2000. Make sure that it is
kept free of all obstructions and that cool, fresh air is accessible at all times.
Also, try to ensure that the Model 2000 is used in a dust-free environment.
4. HPF Off/On switch - When on, the very lowest (subsonic) frequencies output
by your Model 2000 are filtered (removed), providing protection to connected
speakers. As a result, speaker movement (excursion) will be reduced, thus
significantly extending the life of your speakers.
Hartke Systems
Distributed Exclusively by
Samson Technologies Corp.
Hicksville, New York 11802
MODEL 2000
200 WATTS
8Ω = 120 WATTS
4Ω = 200 WATTS
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICE-
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE.
ASSEMBLED IN R.O.K.
SERIAL NUMBER
115
~ AC INPUT
115V/230V 50/60Hz
FUSE
5A/250V, 180W (115V)
2.5A/250V, 450W (230V)
SPEAKER OUTPUTS
8Ω
8Ω
ON OFF
HPF
2
1 3 5
4
EFFECT
SEND
RETUIRN
6
7
We recommend that you keep the HPF Off/On switch at the “On” position
at all times unless you are specifically using the Model 2000 with speakers
specifically designed for ultra-low frequency reproduction (i.e. sub-
woofers). Speaker damage (to Hartke transducers) will not be covered by
warranty if it is determined to have been caused by over-excursion.