Specifications

4
Features
The Hartke Systems Model 2000/3500 Bass Amplifiers offer all the newest
concepts in bass amplification. Here are some of their main features:
Power to sparein the case of the Model 2000, 200 watts into 4 ohms, and,
in the case of the Model 3500, a full 350 watts into 4 ohms.
Our unique Transient Attack® circuitry which ensures that every nuance of
your bass performance is reproduced faithfully.
Two Pre-Amp input knobs, allowing custom blending of tube and solid state
sounds.
Ten bands of high-quality graphic equalization, allowing you to create a
broad range of tonal colors for your bass instrument. A dedicated in/out but-
ton allows you to preset an equalization curve.
Two fully adjustable contour knobs (high pass and low pass), which provide
further control over shaping your bass sound.
A built-in compressor which not only adds real punch to your bass sound,
but also allows you to smooth out volume differences between notes.
Two independent inputs that accommodate both passive and active bass
guitars.
Protection relay circuitry that protects connected speakers from dangerous
overloading and also prevents thumps when powering on or off.
Effect loop send and return jacks that allow you to connect to professional
outboard effects processors.
In the Model 3500, an effect Balance knob which enables you to adjust the
relative amount of Send (dry) versus Return (wet) effect signal being
routed to the speaker outputs.
In the Model 3500, an electronically balanced direct output that provides a
means of routing signal to professional mixing consoles in both live perfor-
mance and recording environments. A ground loop switch helps prevent
hum or buzz from entering the signal, and a pre/post switch allows the direct
signal to be derived either before or after the amp EQ section.
In the Model 3500, LEDs that show you the settings of the graphic equalizer
in low-light environments as well as a two-color LED that continuously
shows the status of the compression circuitry in response to your playing.
In the Model 2000, a high pass filter on/off switch that enables connected
speakers to be protected from subsonic frequency input.
Rugged construction makes both the Model 2000 and Model 3500 eminently
road-worthy.