Specifications

Quick Start

details).

If you hear a weak, noisy signal at the desired volume level, make sure that the gain structure of your audio system and the

Audio Output Level switch are set correctly. If the Audio Output Level switch is set correctly and the signal coming from the

receiver is still weak and/or noisy, simply position the microphone closer to your mouth.

If you feel that the level of the microphone needs further adjustment, press and hold the AL2 Multi-Function Switch while the

unit is powered on until the Status Indicator turns off; then release the switch. Press and hold the Multi-Function Switch again

for five seconds. The AL2 Status Indicator will first flash GREEN, then flash YELLOW, to show that you are in Volume Adjustment

mode. Press and release the Multi-Function Switch once, and the microphone volume will increase one level. To continue

to adjust the microphone volume, continue to press and release the Multi-Function Switch. There are five levels. With each

increasing level, the Status Indicator will flash faster. After level five is reached, the transmitter will cycle back down through

the levels each time the Multi-Function Switch is pressed. As the levels decrease, the Status Indicator flashes slower. When the

desired level is reached, release the Multi-Function Switch. The AL2 will return to normal operation after 10 seconds, and the

Status Indicator will light steady GREEN.

12. Do a walk-around through the intended area of coverage while observing the AR2’s Status Indicator; it should stay steadily

GREEN, indicating sufficient RF reception in all areas of intended use. If the AR2’s Status Indicator lights YELLOW, it signals RF

dropout (or the receiver may be muted). Reposition the device (or its antennas) as necessary. If extended range coverage is

required, another AR2 true diversity receiver (set to the same channel as the transmitter) should be used.

13. If you have followed all of the above the steps and are still experiencing difficulties with your system, please call Samson Tech-

nical Support (1-800-372-6766). If you purchased your system outside of the U.S., please contact your local distributor.