Specifications

About Compression

The dynamic range of a sound is the difference between its loudest and softest points.

For example, as you play your bass, you’ll probably find that some notes (for example,

notes played on the upper frets of the lowest string) are considerably louder than others.

The function of the compressor in the Model 1400/1415 Bass Amplifier is to reduce over-

all dynamic range by automatically attenuating the loudest sounds input so that they are

closer in level to softer ones—the end result is that the sound “evens out” and all notes

played have pretty much the same level.

When you press in the “Compression” switch on the front panel, this automatic circuitry is

engaged and the loudest sounds you play (those that might cause 1% or more of Total

Harmonic Distortion) are reduced in level so that they more closely match the level of

softer sounds—when this occurs, the Compression LED will flash. Very loud sounds will

limited—this is a more severe form of compression, whereby the output remains virtu-

ally constant regardless of input. When this occurs, the Compression LED will light

steadily.

Compression has three main uses. First, as just described, it “evens” out the notes

played by your bass so that they all appear at virtually equal level. Second, it adds

“punch” to a sound; since all levels are nearly the same, you can play with greater force

without worrying about the loudest notes distorting. Finally, it serves to protect your loud-

speakers from damage as a result of brief (

transient) high output levels, as might be

caused by finger-popping or other performance techniques. The Model 1400/1415 com-

pression circuit uses a function called soft clipping to prevent sounds from overloading

the amplifier output—this, in turn, serves to prevent connected speakers from producing

distorted,

hard clipped sound.

Whether or not you need to use compression with your Model 1400/1415 will be a matter

of personal taste and playing style—experiment and see if you like the effect. If you usu-

ally play at low Volume levels, you’ll find that, even with the Compression switch in, the

Compression LED doesn’t flash or light at all—in this case, the circuitry isn’t being used

anyway, so it might as well be off. In general, if you don’t need compression, leave it off.

COMPRESSION

ONOFF

COMPRESSION