Operating instructions

EB 8384-6 EN 73

Start-up – Settings

Table 9 · Reset functions Reset Code 36

Diag Std DS

26 Limit A1 NO

YES

27 Limit A2 NO YES YES

32 Error message in case of 'Function check' condensed state NO YES YES

Error message in case of 'Maintenance required' and 'Out of

specification' condensed state

NO YES YES

38 Inductive limit switch NO NO NO

46 Bus address NO NO YES

48 - Diagnosis

d5 Zero point limit

d11 Principle of operation (actuator) NO NO YES

h0 Initialization including valve signature NO YES YES

h3 Desired time until 'Reset diagnostic measured data' NO NO YES

49 - Partial stroke test (PST)

A2 Test start NO NO NO

A3 Enter test interval NO YES YES

A8 Activate

p out monitoring NO YES YES

p out monitoring value NO YES YES

d2 Lower range value NO YES YES

d3 Upper range value NO YES YES

d4 Activate ramp function NO YES YES

d5 Ramp time (increasing) NO YES YES

d6 Ramp time (decreasing) NO YES YES

d7 Settling time before starting test NO YES YES

d8 Waiting time after step change NO YES YES

d9 Sampling time YES YES YES

E0 Activate x monitoring NO YES YES

E1 x monitoring value NO YES YES

E5 Activate PST tolerance band monitoring NO YES YES

E6 PST tolerance band NO YES YES

E7 Max. test duration YES YES YES

h0 Type of application NO YES YES

h1 Operating point NO YES YES

h2 Fail-safe action limit NO YES YES

h5 Operating point limit NO YES YES