Specifications

10
Setting Up and Using the
HS 1200 Bass Amplifier
Setting up your Hartke Systems HS 1200 KickBack™ Bass Amplifier is
a simple procedure which takes only a few minutes:
1. Remove all packing materials (save them in case of need for future
service) and decide where the amplifier is to be physically placed.
To avoid potential overheating problems, make sure that the rear
panel is unobstructed and that there is good ventilation around the
entire unit. The HS 1200 may be used flat on the floor or in its
“KickBack™” position (for increased high frequency clarity and
directionality), as shown in the illustration below: