Instruction Manual

PAGE 2 OF 3
SamsonRope.com | Email [e-mail] | Tel [phone]
12-Strand Class II Tuck-Bury End-For-End Splice
SAMSON SPLICING INSTRUCTIONS
s
z
Bury the remaining braided strands down the center of the rope,
entering at Mark 1 and exiting at Mark 2. The tail should enter
the standing part of the rope at the same point where the 3
loose strands passed through. Pull the tail out at Mark 2.
Route the remaining 3 strands from
the entry point to their exit points.
Repeat Steps 4, 4A, and 4B on the
opposite end of the rope.
4A
4B
z
s
s
z
Mark 2
Mark 1
Mark 1
Mark 2
s
z
s
z
z
s
Mark 1
Mark 1
Mark 2
fid
Mark 2
s
z
s
z
z
s
s
z
s
z
s
z
5
step
TAPERING THE TAILS
At the end of the tapered tail, remove the d and any tape at
the end of the tail. From the end of the tail, mark 3 consecutive
strands, as shown. Pull them out of the braid and cut off
close to the body of the rope.
Pull out marked strands and cut off
Mark 3 consecutive strands
s
z
z
Mark 2
Mark 1
Mark 1
s
z
z
s
z
s
s
z
s
Mark 2
Smooth rope
Smooth rope
Remove the tape from the end of the tails. Now smooth the
rope from the crossover toward Mark 2 to bury the tails.
5B
Rope B
Rope A
s
z
z
Mark 2
Mark 1
Mark 1
s
z
z
s
z
s
s
z
s
Mark 2