USER MANUAL BLD-7412BT FCC ID: 2AHR7- BLD-7412BT 1
Remote control that Remote control us precautions 1. Under normal circumstances, the remote control should be received in the remote window of about 6 meters, 30 range. 2. Operate the remote control, remote control receiver window of the remote control at the amplifier, remote control and the amplifier should not be an obstacle 3. If the remote receiver is in the position of the remote control directly receive strong light may not be valid. In this case, place the subwoofer away in order. 4.
Back Panel 1.FM antenna 2.Power indicator light 3.Connect to DC power, please be sure connect 4.Switch ON/OFF 5.
DVD Panel (1) (2) (3) (4) (5) (6) (7) (8) (9) DVD: DVD slot Screen Press this button to enter DVD open, press again to enter DVD close Press this button to enter pause , press again to enter play Press this button to select the previous channel Press this button to select the next channel USB: Put USB into the slot GAME: Put game into the slot POWER: Power on/off switch 6
Front Panel 1.Connect with wire microphone 2.Connect with wire microphone 3.AUX input 4.VDP/AUX switchove 5.Input: Press this button to enter BT mode, press again to enter other modes 6.PREV: Press this button to select the previous channel 7.SD/MMC CARD: Put SD card into the slot( Max up to 16GB) 8.PLAY 9.NEXT: Press this button to select the next channel 10.USB: is the mode of USB flash 11.Adjust the volume of the whole unit 12.EQ NOTE: this unit only plays MP3 and WMA files from SD/MMC/USB.
How TO USE WIRELESS MICROPHONE 1. When using included wireless Microphone, switch on microphone, make sure unit power is on. 2. Microphone is designed to be used together with this unit only. 3. Wireless microphone uses AA”*2 batteries (not included), make sure batteries are charged. 4. Wireless MIC Antenna to be used for better reception of wireless microphone while using karaoke. 5. The wireless microphone operating range is 210.3MHz, and the MAX transmitted power is 10mW.
avoid the unit damaged by its inside temperature’s abrupt rising 2. Please do not expose the unit under the sunshine directly or place it near the heat source equipment’s 3. Please do not place any container with water or fine liquid. If there is any liquid in ,please plug out the power cord and contact with the professional repair 4. Please do not open the unit to contact the inside components, otherwise it may cause electric shock or unit damage.
The use of power should correspond with the mark Voltage Values , otherwise it will not play If appear contingent dead halt, please restart the machine FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
