Instructions / Assembly

ManualsBrandsSamsGazebos ManualsArbors8-1/2 ft. x 94 in. Japanese Shinmei Style Wooden Torii Garden Gate

SamsGazebos

○

Japanese Shinmei Style Torii Gate

Assembly Instructions & Installation Guide

Thank you for purchasing a Japanese Myojin Style Torii Gate from SamsGazebos. Assembling it may take 45 minutes and an

hour to set with cement. Minimum two persons are recommended to assemble this item for your safety. Please work on a

clean level floor for the best result. Remove the wrapping material, prepare the tools and material, and lay out the parts before

assembly in order to save you time and effort. Each kit is custom built with pilot holes for your convenience. Wash hands after

handling.

Tools / things you need:

◇ Cordless Screw Driver or Philips Screw Driver(+)

◇ 2 Socket Wrenches

◇ Hammer

◇ Level

◇ Ladder

◇ Square

◇ Knife

◇ Pencil / Pen

◇ Measure Tape

◇ Shovel

◇ Minimum 4 bags of ready mix cement (Get extra bags of cement if you have large holes.)

◇ Wheelbarrow or container to mix cement

◇ Water

◇ Nitrile Gloves (included)

◇ 2 Strings (included)

◇ Hardware is included: four 1/2” x 10” lag bolts with washers and four screws (2-1/2”)

Made in USA

1 Kasagi

1 Nuki

2 Hashira

4 Wood Pegs

1 Extra Wood Board

2 Cement Frames & Strings

2 Wood Blocks

HANDLE With CARE

Do not drop poles.

Summary of content (8 pages)

PAGE 1
SamsGazebos○R Japanese Shinmei Style Torii Gate Assembly Instructions & Installation Guide 1 Kasagi 1 Nuki 2 Hashira 4 Wood Pegs 1 Extra Wood Board 2 Cement Frames & Strings 2 Wood Blocks Thank you for purchasing a Japanese Myojin Style Torii Gate from SamsGazebos. Assembling it may take 45 minutes and an hour to set with cement. Minimum two persons are recommended to assemble this item for your safety. Please work on a clean level floor for the best result.
PAGE 2
Minimum hole ATTENTION: dimensions : 12” W x 12”L x 18” D 1. Making two holes for Torii poles. Remember that you need to set minimum 6” with cement.(See marks on posts.) *Take time to check the LEVEL; it is VERY difficult to correct the Torii position later. 2. Place two wood blocks in the holes. Put a temporary wood board at top to check the level; it will facilitate the Torii installation. Remove the wood blocks. FRAGILE 3. Place two Hashira poles with a hole inside.
PAGE 3
7. Fasten the Nuki and the HASHIRA poles with lag bolts from a side. Leave loose until later. 8. Do the same on the other side. Leave loose until later. 9. A view from the other side. 10. Insert square frames and tie them to the NUKI. this step if you prefer not to use the cement frames. 11. Place a temporary wood board where marked. 12. Be sure to align the marked lines.
PAGE 4
13. Fasten the temporary wood board to the Hashira poles with two screws each. 14. Do the same on the other Hashira pole. FRAGILE 15. Gently put Kasagi from top. 16. Handle with care. IMPORTANT: It is EXTREMLY important that you set each side of Torii LEVEL. 17. Fasten the KASAGI and the Hashira poles with lag bolts. 18. Two lag bolts from top.
PAGE 5
19. Fasten wood pegs to cover the holes with nails. Match the number or alphabet. 20. Fasten the loose lag bolts from sides (steps 7 and 8). IMPORTANT: It is EXTREMLY important that you set each side of Torii LEVEL. 21. Fasten wood pegs to cover the holes with nails. Match the number or alphabet. 22. Pour mixed concrete into the holes and insert the poles. Check the level and adjust the pole positions if it is not level. 23. Check the level from front or back. positions if not level. 24.
PAGE 6
RECOMMENDED FINISHES This product is treated with oil-based semi-transparent brown wood preservative. The color of the wood preservative is not permanent, will show trace of green from Copper and become lighter over time. CopperR Green○ BROWN wood preservative is available at your local Home Depot ○R for a darker, rustic look. Finishing with a deck stain is highly recommended; it is a matt finish will look same for 5 to 10 years.
PAGE 7
SamsGazebos○R Japanese Shinmei Style Torii Gate Care and Use info@samsgazebos.com 1(800) 376-7267 Torii CARE AND USE This product is made for a gate. This is not a structure to climb. Do not leave it without permanent cement installation. This product is treated with oil-based semi-transparent brown wood preservative. The color of the wood preservative is not permanent, will show trace of green from Copper, and turn to light brown R over time.
PAGE 8
SamsGazebos○R Japanese Shinmei Style Torii Gate Parts List info@samsgazebos.com 1(800) 376-7267 1 Kasagi 1 Nuki 2 Hashira 1 Temporary wood board 2 Cement Frames & Strings 2.