Installation Guide

For more details on mounting or additional technical information, visit the

Connected Sites knowledge base at samsara.com/support

1x 1x4x 4x 2x

INSTALL GUIDE — FMS

GUIDE D’INSTALLATION — FMS

INSTALLATIONSANLEITUNG — FMS

GUÍA DE INSTALACIÓN — FMS

GUIDA ALL’INSTALLAZIONE — FMS

INSTALLATIEGIDS — FMS

Bullet IP Site Camera

SC21

PAGE 1
Bullet IP Site Camera SC21 INSTALL GUIDE — FMS GUIDE D’INSTALLATION — FMS INSTALLATIONSANLEITUNG — FMS GUÍA DE INSTALACIÓN — FMS GUIDA ALL’INSTALLAZIONE — FMS INSTALLATIEGIDS — FMS 1x 1x 1x 1x 4x For more details on mounting or additional technical information, visit the Connected Sites knowledge base at samsara.
PAGE 2
1 2 Attach cable gland if using outdoors or in a wet environment. If necessary, install drywall anchors using the alignment sticker for reference. Feed the ethernet cable through the middle opening of the back plate, then fasten the back plate to the mounting surface using the provided screws. Note: The SC21 has cabling to support different deployments and features. Only the ethernet cable is necessary for this install.
PAGE 3
5 6 Add Cameras Loosen camera pan screw with Torx driver provided. When your camera is plugged into the network, add the camera to your dashboard by going to Devices > Cameras > Add Cameras. You can identify your camera in the results via the serial and/or MAC address printed on the camera's box. 8a 7 Once added, confirm the camera is positioned correctly by viewing it in the mobile app or dashboard. The next steps demonstrate the different axes you can use to adjust the camera's field of view.
PAGE 4
8c 8b Optional: Tilt camera. Optional: Tighten the fastening ring. 9 Tighten camera pan screw with Torx driver. samsara.