User's Manual

Encryption Mode:
None – Disable the Encryption mode.
WEP – Enabled the WEP Data Encryption. When the item is selected, you have to
continue setting the WEP Key Length & the key Index.
TKIP – TKIP (Temporal Key Integrity Protocol) changes the temporal key every 10000
packets (a packet is a kind of message transmitted over a network). This insures much
greater security than the standard WEP security.
AES – AES has been developed to ensure the highest degree of security and authenticity
for digital information and it is the most advanced solution defined by IEEE 802.11i for the
security in the wireless network.
Note: All devices in the network should use the same encryption method to ensure the
communication.
WPA Pre-Shared Key: The WPA-PSK key can be from 8 to 64 characters and can be letters
or numbers. This same key must be used on all of the wireless stations in the network.
WEP Key (Key1~Key4): Only valid when using WEP encryption algorithm. The WEP keys are
used to encrypt data transmitted in the wireless network. There are two types of key length:
64-bit & 128-bit. Select the default encryption key form key1 to key4 by selected the radio
button.
Fill the text box by following the rule below:
64-bit – Input 10-digit Hex values (in the “A-F”, “a-f, and “0-9” range) or 5-digit ASCII
characters (including “a-z” and “0-9”) as the encryption keys. For example: “0123456aef”
or “test1”
128-bit – Input 26-digit Hex values (in the “A-F”, “a-f, and “0-9” range) or 13-digit ASCII
characters (including “a-z” and “0-9”) as the encryption keys. For example:
“01234567890123456789abcdef” or “administrator”
3.3.3 802.1x Setting-Certification
The IEEE 802.1X specification describes a protocol that can be used for authenticating