User's Manual

802.11g Wireless LAN+BT SiP combo Module V2.2
All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI.
Preliminary release for evaluation, Subject to be changed without Notice
bus. HD[15:0] are used to access the MODULE
MAC Host Interface register
Databus
3 D04 HD4 Data Input/Output line constitute a bi-directional
bus. HD[15:0] are used to access the MODULE
MAC Host Interface register
O, PD, 5VT, 4mA
Databus
4 D05 HD5 Data Input/Output line constitute a bi-directional
bus. HD[15:0] are used to access the MODULE
MAC Host Interface register
IO, PD, 5VT, 4mA
Databus
5 D06 HD6 Data Input/Output line constitute a bi-directional
bus. HD[15:0] are used to access the MODULE
MAC Host Interface register
IO, PD, 5VT, 4mA
6 D07 HD7 Data Input/Output line constitute a bi-directional
bus. HD[15:0] are used to access the MODULE
MAC Host Interface register
IO, PD, 5VT, 4mA
7 -CE_1 HCE1_B Card Enable1 is driven by the host system and is
used as select strobe in both I/O and memory
mode. Enables even numbered address bytes.
Input, PU, 5VT
8 A10 A10 ADDRESS BUS lines driven by the host system
which enables addressing of 0.5K address range
within MAC. This address range is mainly used for
accessing the CIS in Memory Mode. Signal HA0 is
not used in word access mode.The pin is open in
B2B module.
Input, PD,5VT
9 -OE HOE_B OUTPUT ENABLE is driven by the host during a
memory Read Access.
Input, PU,5VT
10 A09 HA9 ADDRESS BUS lines driven by the host system
which enables addressing of 0.5K address range
within MAC. This address range is mainly used for
accessing the CIS in Memory Mode. Signal HA0 is
not used in word access mode.
Input, PD,5VT
11 A08 HA8 ADDRESS BUS lines driven by the host system
which enables addressing of 0.5K address range
within MAC. This address range is mainly used for
accessing the CIS in Memory Mode. Signal HA0 is
not used in word access mode.
Input, PD,5VT
12 A07 HA7 ADDRESS BUS lines driven by the host system
which enables addressing of 0.5K address range
within MAC. This address range is mainly used for
accessing the CIS in Memory Mode. Signal HA0 is
not used in word access mode.
Input, PD,5VT
13 VCC VCC_WLAN Power, 3.3V_WLAN Input
14 A06 HA6 ADDRESS BUS lines driven by the host system
which enables addressing of 0.5K address range
within MAC. This address range is mainly used for
accessing the CIS in Memory Mode. Signal HA0 is
not used in word access mode.
Input, PD, 5VT
15 A05 HA5 ADDRESS BUS lines driven by the host system
which enables addressing of 0.5K address range
within MAC. This address range is mainly used for
accessing the CIS in Memory Mode. Signal HA0 is
not used in word access mode.
Input, PD, 5VT
16 A04 HA4
ADDRESS BUS lines driven by the host system
which enables addressing of 0.5K address range
within MAC. This address range is mainly used for
Input, PD, 5VT