User's Manual

SmarTerminal® |Fully rugged TiTAN T8

Leader in RF Technology

PenMount Control Panel

The functions under PenMount Control Panel are:

Device

In this tab, you can find out how many devices are detected on your system.

Select any device by clicking on its icon.

Calibrate

This function offers two ways to calibrate your touchscreen. ‘Standard

Calibration’ adjusts most touchscreens while ‘Advanced Calibration’ adjusts aging touchscreens.

Standard Calibration Click this button and arrows appear pointing to red

Advanced

Calibration

Command

Calibration

To calibrate your touchscreen:

1. Please select a device then click “Configure”. You can also double click the device too.

squares. Use your finger or stylus to touch the red squares in

sequence. After the fifth red point

calibration is complete. To skip, press ‘ESC’.

Advanced Calibration uses 9, 16 or 25 points to

effectively calibrate touch panel linearity of aged

touchscreens. Click this button and touch the red

squares in sequence with a stylus. To skip, press

‘ESC’.

Command call calibration function. Use command mode call calibration

function, this can uses Standard, 4, 9, 16 or 25 points to calibrate.

E.g. Please run ms-dos prompt or command prompt.

c:\Program Files\PenMount Universal

Driver\DMCCtrl.exe -calibration 0 (Standard

Calibration)

DMCCtrl.exe - calibration ($)

0= Standard Calibration

4=Advanced Calibration 4

9=Advanced Calibration 9

16=Advanced Calibration 16

25=Advanced Calibration 25