User's Manual Part 1

CONFIDENTIAL Page 2 2004/8/20
FCC (Federal communiction commission)
This device was tested for typical body-worn operations. The antenna(s) used for
this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. To comply with FCC RF exposure requirements third-party
belt-clips, holsters, and similar accessories used by this device should not contain
any metallic components. Body worn accessories that do not meet these requirements
may not comply with FCC RF exposure requirements and should be avoided. The
FCC had granted an Equipment Authorization for this model device with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment is FCC Class B product and it complies with FCC Part 15 standard. This
equipment must be installed and operated in accordance with provided instructions. End-users
and installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
CONTENTS:
 SmartTablet Web Pad.
 Stylus Pen.
 Protective Cover.(Applicable to the case of Mass Production).