User's Manual

Leader In Mobile

6-3. How to install the antenna

When installing it on the metal materials which may cause the reduction of read range of Tag.

It is recommended to avoid the metal material (SUS material) for bracket which is needed for the

clearance.

1. Review the locations where the Reader products are placed.

Ensure that you have carefully considered the safe distances for product placement for

workers and any other personnel that may get in the RF path.

If the Antenna was purchased with bracket option, which the bracket you can locate your

antenna to a better or higher position to receive or transmit signals.

2. Mount the antenna that use antenna bracket that it is recommended to use Washers

beneath nuts to increase adhesion.

3. Attach the antenna to one of the four antenna ports on the back of the Reader.

Note

1. Avoid metal material the front side of antenna in 2M due to cause of low performance.

2. Antenna cable per each port should be not tangled and tied up.

7. Trouble shooting

Problem

Possible Causes

Corrective Action

Reader is not reading tags. The tag is out of its read

range.

1. Ensure antenna is properly connected.

2. Ensure reader is connected to your

computer.

3. Ensure computer is plugged into AC outlet

and computer is On.

4. Ensure tag is within range of antenna.

Reader error LED stays lit on 1.Block read fail

2.Block write fail

3.Abnormal

disconnected

between RF-Reader

and HOST PC

1. Turn LED lights off when receive new

command.

Cannot connect to the reader. IP address mismatched 1.set the proper IP address