User Manual

MiniStation All-in-One Petit Board User’s Manual
Award BIOS Setup
66
Mouse
Left
This allows system to POWER ON by clicking the left mouse
button. To enable, user must reboot and allow system to finish
booting up otherwise the setting will not take effect.
Mouse
Right
This allows system to POWER ON by clicking the right mouse
button. To enable this setting, user must reboot and allow
system to finish the boot up process otherwise the setting will
not take effect.
z Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to
use it. If you install an add-in FDC or the system has no floppy drive, select Disabled in this field. The default
value is “Enabled”.
z Onboard Serial Port 1/2/3/4
Select an address and corresponding interrupt for the first and second serial ports. The default values are
“3F8/IRQ4” for Onboard Serial Port 1, “2F8/IRQ3” for Onboard Serial Port 2, “3E8H/IRQ10” for Onboard Serial
Port 3, and “2E8H/IRQ11” for Onboard Serial Port 4.
z UART Mode Select
The second serial port offers these infrared interface modes:
1.
IrDA
2. ASKIR IrDA-compliant serial infrared port
3. Standard (default value)
NOTE:
The UART Mode Select will not appear on the menu once you disable the setting of Onboard Serial
Port 2.
When UART Mode Select is set as ASKIR or IrDA, the options RxD, TxD Active and IR Transmittion delay
will appear.
z Onboard Parallel Port
Select a logical LPT port name and matching address for the physical parallel (printer) port. The default value is
“378/IRQ7”.
NOTE: Choosing Disabled for this option will remove the Parallel Port Mode option on the menu.